Newsletter #67-2021 19 ESIS Procedures and Documents (free available for ESIS Members at www.structuralintegrity.eu) Two kinds of documents are produced by ESIS Technical Committees with the following designatory system: ESIS P2-92 or ESIS P4-92D, where: 1. P means "Procedure", and 2 and 4 are the current numbers, while 92 is the year of issue. 2. D following the year (eg: 92D) means "draft", ie: not yet approved, while 3. D prior to the year (eg: D1-92) means "Document" other than test methods. P1-92 ESIS RECOMMENDATIONS FOR DETERMINING THE FRACTURE RESISTANCE OF DUCTILE MATERIALS. Responsible body: TC1 Subcommittee on Fracture Mechanics Testing Standards. P2-92 ESIS PROCEDURE FOR DETERMINING THE FRACTURE BEHAVIOUR OF MATERIALS. Responsible body: TC1 Subcommittee on Fracture Mechanics Testing Standards. P3-03D DRAFT UNIFIED PROCEDURE FOR DETERMINING THE FRACTURE BEHAVIOUR OF MATERIAL. Responsible body: TC1 Subcommittee on Fracture Mechanics Testing Standards (UNDER PREPARATION NOT AVAILABLE). P4-92D ESIS RECOMMENDATIONS FOR STRESS CORROSION TESTING USING PRE-CRACKED SPECIMENS. Responsible body: TC10 Committee on Environmental-Assisted Cracking. P5-00/VAMAS PROCEDURE FOR DETERMINING THE OF FRACTURE TOUGHNESS OF CERAMICS USING THE SEVNB METHOD . Responsible body: TC6 Committee on Ceramics. P6-98 ESIS PROCEDURE TO MEASURE AND CALCULATE MATERIAL PARAMETERS FOR THE LOCAL APPROACH TO FRACTURE USING NOTCHED TENSILE SPECIMENS. Responsible body: TC8 Committee on Numerical Methods. P7-00 ESIS PROCEDURE FOR DYNAMIC TENSILE TESTS Responsible body: TC5 Subcommittee on Dynamic Testing at Intermediate Strain rates. P8-99D ESIS DRAFT CODE OF PRACTICE FOR THE DETERMINATION AND INTERPRETATION OF CYCLIC STRESSSTRAIN DATA. Responsible body: TC11 Committee on High Temperature Mechanical Testing. P9-02D GUIDANCE ON LOCAL APPROACH OF RUPTURE OF METALLIC MATERIALS. (UNDER PREPARATION NOT AVAILABLE). P10-02 A CODE OF PRACTICE FOR CONDUCTING NOTCHED BAR CREEP RUPTURE TESTS AND INTERPRETING THE DATA. Responsible body: TC11 High Temperature Mechanical Testing Committee. P11-02 TECHNICAL RECOMMANDATIONS FOR THE EXTREME VALUE ANALYSIS OF DATA ON LARGE NONMETALLIC INCLUSIONS Responsible body: TC20 Committee on Inclusions. D1-92 FRACTURE CONTROL GUIDELINES FOR STRESS CORROSION CRACKING OF HIGH STRENGTH ALLOYS. Responsible body: TC10 Committee on Environmental Assisted Cracking. D2-99 FRACTURE TOUGHNESS OF CERAMICS USING THE SEVNB METHOD; ROUND ROBIN, TEST PROGRAMME. The ESIS TC6 and VAMAS TWA3 developed a test method and conducted a round robin for its validation. D2-99 presents a detailed documentation of this activity. The final form of the test method has appeared as P5-00. Responsible body: TC6 Committee on Ceramics.
RkJQdWJsaXNoZXIy MjM0NDE=